![]() ![]() (1) Haas TM-1P Tool Room CNC Vertical Mill, RPM Spindle, 47.75” x 10.5” table,30” X travel, 16” Y travel (MN) ![]() ![]() (1) Makino PS95, 14k spindle, CAT 40 taper, 20” x 36” table travel, 30 tool ATC, 1323 lb table capacity (MN) (3) YCM TV-146B, 6000 RPM spindle, CAT 50 Taper, 24” x 55” table travel, 40 tool ATC, 1000 PSI coolant thru spindle, 3300lb table capacity (MN) (1) Supermax TV146B, 10k spindle, CAT 50 Taper, 23.5” x 59” table travel, 40 tool ATC, 3307 lb table capacity (MN) (1) Supermax V116B, 6k spindle, CAT 50 Taper, 23.5” x 47” table travel, 24 tool ATC, 2646 lb table capacity (MN) (1) OKK VM5III Vertical Machining Center, Cat 50 – 10000 RPM Spindle, 30 tool ATC, 1000 psi coolant thru, 22” x 41” table size 1760 lb capacity (MN) (2) Toyoda SB 316 Double Column Vertical Machining Center, Cat 50 – 12000 RPM Spindle, 60 tool ATC, 1000 PSI Coolant thru, 118” x 59” table size, 22000 lb capacity (MN) Mine has jammed up a time or ten and sat stewing for up to half an hour at a time.(1) Mazak VARIAXIS 730-5X, 5 axis, 10k spindle, CAT 50 Taper, 28.7” x 33.4” table travel, 120 tool ATC, 1000 psi coolant thru spindle, 1102 lb table capacity (MN) Ian S C Edited By Ian S C on 11:57:39 Those crafty capacitor in the middle 110 / 220 V motors are remarkably durable. The motor gave up when Dave started a cut, and went off to do something else, the blade jammed, and when he got back all the magic smoke was leaking out. Regards, Richard Over the last 15 years I'v been working with a mate building agricultural machines, the most we have built is 10 one year, total production is over 60(I came in a few years after the start), all the steel in these machines was cut on a 6' x 4' H&V bandsaw, not sure if it's a Chinese, or Taiwanese one, on occasions it cuts off square, but it's usually the blade. If not, I'd say save a bit & get a Clarke one. The bandsaws look to be generally better casting quality than the Clarke ones, or better finished, and the controls seem more ergonomically positioned if you are using them for a long period. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |